Note:
1. Disassembling the miner without permission of after-sales staff will void your warranty (check my warranty). Check after-sales terms to learn more.
2. Ensure that the installation is done correctly before restarting the miner.
3. Incorrect installation may void your warranty.
After receiving the new fans, please ensure to check the condition of the fans and row lines to make sure they are in good condition.
1. Removing the Defective Fan
1.1 Remove the screw in the center of the miner's hash board (as shown in Figure 1).
figure 1
1.2 Remove the screws on the fan surface, pay attention to only remove the outer six screws (as shown in Figure 2).
figure 2
Figure 3
1.3 Slowly pull out the hash board and fans. Make sure the position of the bad fans, pls take the following picture for reference. After-sales staff refer to "fan #1, fan #2" or "fan 1, fan 2" as shown in the Figure4 by Fan #1 and Fan #2.
figure 4
1.4 Unscrew the defective fan(s) (as shown in Figure 5).
figure 5
1.5 Unplug the row lines (as shown in Figure 6).
figure 6
2. Installing the fan
Put the new fans into the correct position, then install. You can take the above tutorial for reference. Remember to confirm the airflow direction when installing. TIP: the air flow arrow should point to BOX inside.
Installing the fan in the wrong direction may lead to the miner shutting down at high temperatures, and even causing irreversible damage!
2.1 Please refer to Figure 7 and observe the symbol on the fan. When installing the fan on the metal plate, make sure that the "AIR FLOW" arrow points towards the inside of the miner, as shown in Figure 7. Install the eight screws of the two fans in their respective positions, as shown in Figure 8.
figure 7
figure 8
2.2 Plug the fan connector into the hash board, making sure that the indicator light and the holes on the metal plate align.
figure 9
figure 10
2.3 Install the assembled fan and hash board according to Figure 11, ensuring that the hash board aligns and fits snugly into the groove.
figure 11
2.4 Install the 6 screws on the fan surface and the 1 screw on the hash board surface. The fan installation is now complete, as shown in Figure 12.
figure 12
Comments
0 comments
Article is closed for comments.