MAX/LITE Series-Instructions on Replacing Hash Board

Note:

1. Disassembling the miner without permission of after-sales staff will void your warranty (check my warranty). Click our after-sales terms to learn more.

2. Ensure that the installation is done correctly before restarting the miner.

3. Incorrect installation may void your warranty.

1. Remove the Hash Board from the Miner

1.1 Remove the screws located above the fans at the back of the miner.

1.2 Remove the top case.

 1.3 Remove the screws at the back of the miner.

1.4 Unplug the ribbon cable(s).

1.5 Remove screws on the mental bar.

1.6 Take out the hash board.

After-sales staff refer to the hashboards as Hashboard 1, 2, 3, and 4, corresponding to the numbers 1–4 shown in the figure below.

2. Install the Hash Board

2.1 Put the hash board in the correct position.

2.2 Tighten the screws on the mental bar.

Please make sure all screws are fully tightened, especially the ones on the mental bar. Loose screws may cause overheating and lead to damage or burning.

2.3 Plug the ribbon cable(s).

2.4 Tighten the screws at the back for the miner.

2.5 Carefully install the top board of the miner.

2.6 Tighten screws at the back of the miner. And then installation complete!

Make sure all screws are tightened securely!